can not create a solid because of naked edges

 From:  BurrMan
10977.9 In reply to 10977.8 
The little fillets in the sweep path all have a very tiny deviation from tangent, so the mitering sweep kicks in and makes little bad surfaces all over.

I corrected the tangencies and the 2 palnars join to a solid good.

I can make a video of fixing it if anyone wants to see that. I did most of it with the line tool checking point tangencies. I could get them all except for 4 of the top (Y direction) fillets. So I separated and deleted those and used blend to fill back in...

I left a little sphere in this file where to look on the original files sweep to see the bad geometry (Just one obvious one) In case you wanted to see the original problem.

Anyway...
Attachments: