Anyone who frequently uses Make2D to generate linework will be familiar with the need to make lots of trims- sometimes hundreds on perspective views of threaded fasteners. A while back I was furiously trimming lines when I realized that MOI was working just the way I'd always wanted it to- when I selected a line on the side I wanted to keep and then selected the intersecting line the trim happened immediately, without the need to select the trimmed section. But, it didn't maintain that behavior, and I thought I must have been having a caffeine hallucination. Then it happened again this morning- I tried to find some option or checkbox that resulted in this action, but I couldn't, and in trying different options the behavior disappeared again. Is there an option to make this behavior stick? I know MOI is capable of working this way but can't reproduce it- if it's a bug I hope it can be written in.