“””””” > Trim to open up a gap between piece and then Construct > Blend to put in a smooth blend curve to connect between the pieces.”””””

Since the point picker has a radius, can it be scripted or commanded to do a “gap” in a single click?

So like on curves, if you placed a circle of a particular radius and boolean diffed it away from the curve. (The trim and delete part)

The UI could just be a radius/diameter value. It doesn't even need to be joined curves or connected segments. Just delete everything in the radius. (And of course limit the target if something is “selected”….

Brainstorming….. its a dark, grey storm….